首页 > 公司资讯 > 燃烧/阻燃/灼热丝/针焰测试 > 灼热丝试验IEC 60695-2-10-2013最新版材质成分有作了变更有新的要求

灼热丝试验IEC 60695-2-10-2013最新版材质成分有作了变更有新的要求

IEC 60695-2-10:2013着火危险试验--2-10部分:基于灼热/热线试验方法--灼热线装置及通用试验程序            

IEC 60695-2-10-2013 Fire hazard testing -- Part 2-10: Glowing/hot-wire based test methods -- Glow-wire apparatus and common test procedure 


RH-5014 Glow Wire Test Apparatus-Specifications

版本:  2.0  标准状态:  现行


IEC 60695-2-10-2000  着火危险试验 2-10部分:基于灼热/发热丝的试验方法 灼热丝设备及通用试验程序


(CNS)  C80;K04  国际标准分类

(ICS)  13.220.40;29.020 

发布日期:  2013-04-01  实施日期:  2013-04-01 

适用范围:  This part of IEC 60695 specifies the glow-wire apparatus and common test procedure to simulate the effects of thermal stresses which may be produced by heat sources such as glowing elements or overloaded resistors, for short periods, in order to assess the fire hazard by a simulation technique. The test procedure described in this standard is a common test procedure intended for the small-scale tests in which a standardized electrically heated wire is used as a source of ignition. It is a common part of the test procedures applied to end products and to solid electrical insulating materials or other solid combustible materials. A detailed description of each particular test procedure is given in the respective standards IEC 60695-2-11, IEC 60695-2-12 and IEC 60695-2-13. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications. 



  IEC 60584-1  热电偶 1部分:参考表

  IEC 60584-2  热电偶 2部分:允差

  IEC 60695-2-11  着火危险试验 2-11部分:基于灼热/发热丝的试验方法 最终产物的灼热丝易燃性试验

  IEC 60695-2-12  火灾隐患试验.2-12部分:基于灼热/发热丝的试验方法.材料的灼热丝可燃性指数(GWFI)试验方法

  IEC 60695-2-13  着火危险试验.2-13部分:基于灼热/发热丝的试验方法.材料的灼热丝着火点(GWIT)试验方法

  IEC Guide 104-2010 

  ISO 13943-2008  消防安全--词汇表

  ISO 4046-4-2002  ,纸板,纸浆和类似术语-词汇-4部分:纸和纸板等级和转换产品

  ISO/IEC Guide 51-1999  标准中安全问题导则.


 IEC 61730-1-2013  光伏(PV)组件的安全鉴定--1部分:结构要求

    [ 上一页: UL94水平垂直燃烧试验箱通过深圳美信检测评估及采购 ]
    [ 下一页: 祝贺被UL实验室认可的UL电线燃烧试验箱中标升辉电线电缆(深圳)有限公司 ]